Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 248 / 318

Section 6 Maintenance F103/4/5A Manual
www.rottlermfg.com
6-61
• Dial the probe stylus into center using a .0001” indicator to within .0005” the tighter tolerance you hold
the more accurate the machine will be. You must use an indicator that takes very little pressure to get
a reading. Excessive pressure on the stylus will deflect the probe and you will not be able to dial it in
correctly.
• Go to the Main/Block Model screen and select the Table of Tools. You may only have a Default Tool
#0 listed.
• Press Add Tool. This will bring up a dialog box. Change the name from default tool to probe style that
you are installing i.e. 50mm stylus, 100mm stylus. Set the diameter to .2360” this is default probe tip
on a 50mm,100mm, and 17.5mm.
• Install a block, or parallels onto the machine and secure it solidly to the machine table.
•
Place the Ring Gauge onto the top of the block, use Probe Auto Center to find center zero your X
and Y axis here. Make sure you use a ring gauge or a hole of a known diameter. This will set the
correct probe timing.
• Adjust the probed diameter by going to the IO under Setup Electronics and changing the Probe MS.
You will need to increase or decrease the MS of the probe to achieve correct Probe Diameter.
• Repeat until the correct diameter is displayed.
• Probe Auto Center the ring gauge, without moving X or Y, remove the probe up in Z and Install the
cutter head. Put a magnet base with the Last Word indicator on the cutter head and sweep the
cylinder/ring gauge.
• The variation in X and Y Should be less than .0005.
• If not add compensation to ProbeOffSet under > Setup Eletronics-Addins-ProbeSetup