Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 80 / 318

Section 4 Control Definitions F103/4/5A Manual
www.rottlermfg.com
4-26
Install the first tool such as the 2.9 Production Stub with Cutting insert installed. Bring the cutting insert
down until it just touches the flat on the head stock of the 4th axis fixture. Go to the TABLE OF TOOLS
and double click the 2.9 Production Stub tool. Select Get Length from that window. This will bring up the
Tool Length window.
Z Location from Zero
This is the distance the Vertical Axis is from the home position. NOT where the operator has set the
Vertical Zero in the program. This value is set by the computer automatically. In this example the tool just
touched the flat at 8.0000.
Z Touch Off Height
This value is an additional value you want added to the Z location from zero. For example, if you wanted
to use the center of the Crankshaft as the vertical reference point, but you are touching the tool off of the
flat of that head stock, you would enter the distance from where you are touching off to the center of the
Crank (this value is stamped into the headstock by Rottler). The values from Z Location from Zero and
Z Touch off Height are added together by the computer to get the Final tool Length value. If you are not
referencing another vertical position then this value will remain 00.000.
Add Tool Radius?
Checking this box will add the Tool Radius to the Final Tool Length. This is not used in the Rottler
programs and should remain unchecked for all tools.