Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 144 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-57
Bore Locations
To build a program you must set the Horizontal and In/Out Stops for the program All Horizontal and In/Out
stop are based from where their zero positions were set.
Select Left Locations and the Blueprint. Program the blueprint values (or close approximation) into the
Horizontal and In/Out stops. Do the same for the Right Locations.
Select Left Locations and then Probing. You can probe each cylinder individual by pressing the
associated Probe button or you can probe the entire bank by pressing the Probe Left Button. This is the
same procedure for the Right Bank.
Probe Auto Center
This feature is located on the Set Zero page. This allows easily find the center of a hole or cylinder.
Roughly place the probe in the center of a cylinder. Press Probe Auto Center. The cylinder will be probed
in 4 places, when finished the probe will move to the center of the probed cylinder. Pressing Horizontal
and In/Out zero will then establish the center of that hole.
Automatic Probing Procedure
The probe will move to the center of the cylinder to be probed. It will then move to the right at a slow
rate until the side of the cylinder is touched, it will then back off slightly and touch the same spot again to
confirm position. The probe will then touch off the cylinder in three more spots and retract from cylinder.
As each cylinder is probed the Probed Diameter, Horizontal and In/Out positions will be placed into the
Data Boxes for the corresponding cylinder.
Press the Right Locations tab and repeat the above procedure for the cylinders to be probed on the right
bank.
The Horizontal and In/Out stops have now been set.