Rottler F103 Series, Руководство по установке, эксплуатации и обслуживанию

Страница: 119 / 318

Section 5 Operating Instructions F103/4/5A Manual
www.rottlermfg.com
5-32
Typical Head Set Up Procedure
Find the desired ports or bosses, in the head, to position cones (long or short) on rear support blocks.
Measure the distance between the centerlines of these ports (bosses) within 1/16” (1mm – 5mm).
Measure the distance from rear support points to front support points on the head.
Position rear support blocks and front support blocks to hold the head approximately centered on the
table top and spaced apart per dimensions measured in step ‘1’ above. Generally, place the front blocks
closer together than the rear blocks. If necessary, use either 2 or 4 spacers to raise the head for clearing
studs or to angle the head so the cutterhead clears the head clamp handle assembly.
Place the head on the support blocks. Elevate the cones to ‘hook’ the two ports (bosses) on the head and
tighten their set-screws. Adjust the position of the front support blocks if necessary. Tighten the hex bolts
on the support blocks. Push the head back firmly into the cones. Adjust the support block jack to eliminate
any rocking of the head. Do not tighten the head clamp handle assembly yet.
Unlock the table. Using the two hand-wheels, level the head surface to be cut. Lock the table in this
position.