Roland R4000, Руководство пользователя

Страница: 158 / 172

Manual
Weld Seam Detection System R4000 SND40
for Tubes, Cans and Drums
Technical records B0059001 / Rev. 2.3
158 ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Pos: 125 /Schweissnaht/Gerä te/SND40/11 Technische Unterla gen/Se rvice/Da tensiche rung über Netzwe rk @ 0\mod_1143643120734_501.docx @ 2005 @ 3 @ 1
11.2.3 Data backup via network
Data backup can be done via Ethernet or by USB interface (for newer hardware).
Data backup via Ethernet is performed within a
Telnet session.
Note: For the term “
Host-PC-name
” used in this section, the respective Windows name of the
PC must be inserted. The PC name can be found via
“
my computer
” -> “
properties
” -> “
computer name
”.
1. Create a new folder, e.g. „ SND40-backup “ on the Host PC, which permits full access with the
access name „
netdcu
“.
2. Start a Telnet session on the Host PC (towards SND40).
Therefore:
• Open the command prompt (Start > Run) and enter "
CMD " and confirm with <ENTER>.
• Enter “ telnet 192.168.100.107 “ and confirm with <ENTER>.
3. Copy data:
Generally: Always copy data from / to folder “ ffsdisk ” on the SND40.
Copy files from the SND40 to the Host PC:
• Enter “
cd \ffsdisk ” and confirm with <ENTER>.
• Enter ” copy *.cfg \\Host-PC-name\netdcu\ “ and confirm with <ENTER>
(this will copy the program files and the system settings).
• Enter ” copy statistics.log \\Host-PC-name\netdcu\ “ and confirm with
<ENTER> (this will copy the Log files).
• Now all files should be reported as copied.
• For verification enter “
dir ” and confirm with <ENTER>. All files in the directory will be
shown. Verify if all files have been copied.
Copying files from the HOST PC to the SND40:
Attention! The files on the SND40 will be overwritten without further notice !!!
• Enter “ cd \ffsdisk ” and confirm with <ENTER>.
• Enter ” copy \\“Host-PC-name“\netdcu\*.* “ and confirm with <ENTER>.
• Now all files should be reported as copied.
• For verification enter “
dir ” and confirm with <ENTER>. All files in the directory will be
shown. Verify if all files have been copied.
Data backup via USB stick is performed by the enclosed software ”
SND40Store ”. For details read
” SND40 Store “ in chapter ” Maintenance and repair “. When using newer hardware, a backup via
USB stick should be preferred.
Pos: 126 /Schweissnaht/Gerä te/SND40/11 Technische Unterla gen/Se rvice/Kompo nententausch und Nachrüstung @ 0\mod_1147437807187_501. docx @ 2091 @ 3444 @ 1