Rokonet ORBiT-14, Руководство по установке

Страница: 29 / 60

Installation Manual
23
Location: 008 Installer Code I Default: 0214
The installer code is a 4-digit code used by alarm company personnel authorized to
modify the system’s parameters. It is recommended to change the “factory default”
Installer Code to one of your own choice.
Location: 009 Installer Code II Default: 1214
A 4-digit code that identifies a technician sent by the installation company to carry out
restricted tasks. Using this code, the sub-installer can access only those
programming locations associated with the authority level defined in location
061(refer to page 41).
Location: 010 Master Code Default: 1234
A 4-digit code used by the system's owner or chief user.
The Master Code provides the following special privileges:
•
To enter, modify, and delete the remaining all User Codes
•
To set the system's internal clock
•
To perform certain system functions and tests
NOTE:
The Master Code cannot be seen by the installer through the zone LEDs on the keypad.
System Time Definitions:
Locations 011-016
Location: 011 Exit Delay Default: 030
Establishes the system’s Exit Delay (the interval, in seconds, between entering a
User Code at the keypad and when the system actually arms).
Enter the number of seconds (between 001 and 255).
Location: 012 Entry Delay Default: 060
Establishes the system’s Entry Delay (in an armed system, the interval, in seconds,
between the moment an entry door is opened and an alarm is triggered).
Enter the number of seconds (between 001 and 255).
Location: 013 Bell Cutoff Time Default: 04
Sets the interval that the system’s external sounder(s) will operate during an alarm
before it shuts off automatically.
Enter the number of minutes (between 01 and 90).
NOTE:
The keypad’s buzzer operation is not affected by the Bell Cutoff time definition.