Rokonet ORBiT-14, Руководство по установке

Страница: 25 / 60

Installation Manual
19
3. To enter data into the location:
Press data digits (0 - 9 digits including hexadecimal A-F) followed by #.
Using your LED keypad, you can enter the hexadecimal digits A – F as follows:
To Enter Press
A [STAY] + [1]
B [STAY] + [2]
C [STAY] + [3]
D [STAY] + [4]
E [STAY] + [5]
F [STAY] + [6]
4. To exit programming mode:
Press the 4-digit installer code followed by ARM.
Programming Time Out
If after 10 minutes during the programming time, no entry is made to a keypad that
has been used for the programming operations, it will produce an audible reminder,
consisting of several beeps in rapid succession. Pressing on any key will stop the
beeping and return to the programming mode.
Programming Tutorial
To help acquaint you with some programming basics, a short tutorial has been
prepared. It involves changing the Installer Code from the factory default of
0-2-1-4 to
a sequence of your own choosing. If you can master this operation, subsequent
programming should be easy.
Operation Action Comments
1
Enter the Installer
Programming
mode Enter the factory default
Installer Code (
0-2-1-4 );
followed by # .
A long beep will sound, confirming
successful entry into Installer
Programming.
2
Access the current
Installer Code
(stored in location
“008”)
Press [0] , [0,[8] , [ARM] . No confirming beep will sound.
3
Enter a unique
Installer Code
(for this tutorial, use
3-0-5-7)
Enter [3] , [0] , [5] , [7] . No confirming beep will sound.
4
Store the data
you have entered
Press [#] . A long beep will sound confirming that
data has been properly stored.
If a wrong number of digits entered
three (error) beeps will sound after
pressing #.