Rockwell ShopSeries RC3031K, Руководство пользователя

Страница: 8 / 24

4.5A HAND DRILL ENG
8
TECHNICAL DATA
Voltage: 120V~60Hz
Rated Current: 4.5A
No load speed: 0~2800 rpm
Chuck Capacity: 1/32”-3/8”
Maximum Drilling capacity:
Wood: 1”
Steel: 3/8”
Protection Class: / II
Weight: 3.528Ibs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
1. ON/OFF SWITCH
Depress to start and release to stop your tool.
(See Fig A)
2. VARIABLE SPEED CONTROL SELECTOR (see Fig B)
The maximum speed can be altered by turning the
speed control. Turn clockwise to increase and anti-
clockwise to decrease speed. The speed of the drill
varies with the amount of pressure applied to the
on/off switch, i.e. more pressure for higher speed.
3. SWITCH LOCK-ON BUTTON
Depress ON/OFF switch (5) then lock-on button (3)
(See Fig C), release ON/OFF switch first and lock-on
button second. Your switch is now locked on for
continuous use. To switch off your tool just depress
and release the ON/OFF switch.
4. FORWARD AND REVERSE ROTATION CONTROL (see Fig
D & E)
For drilling and screw driving use forward rotation
marked “ ” (switch is moved to the left). Only use
reverse rotation marked “ ” (switch is moved to the
right) to remove screws or release a jammed drill bit.
Never change the direction of rotation when the tool
is rotating, wait until it has stopped.
5. CHUCK ADJUSTMENT(see Fig F)
To open the chuck jaws rotate the front section of
the chuck while holding the rear section. Insert the
drill bit between the chuck jaws and rotate the front
section in the opposite direction while holding the
rear section. Ensure drill bit is in the center of the
chuck jaws. Finally, firmly rotate the two separate
chuck sections in opposite directions. Your drill bit is
now locked in the chuck.
WARNING: Before installing accessory, remove
plug from power supply. Do not attempt to tighten
drill bits (or any other accessory) by gripping the
front part of the chuck and turning the tool on.
Damage to the chuck and personal injury may result.
6. HORIZONTAL BUBBLE LEVEL (SEE FIG G)
Your drill is equipped with a bubble level that assists
you in drilling level holes. For horizontal drilling, tilt
the drill up or down as required so that the bubble
floats in the center of the parallel lines drawn on the
glass.
NOTE: The level is filled with mineral oil that may
cause minor skin irritation when contacted If the
level breaks and this fluid gets on your skin, rinse
thoroughly with water. If any liquid gets in your eyes,
rinse thoroughly with wafer and call a physician
immediately.
7. BELT CLIP (see Fig H)
With the belt clip, the machine can be hung onto a
belt. The user has both hands free and the machine is
always within reach.
WORKING HINTS FOR YOUR DRILL
If your power tool becomes too hot, set the speed to
maximum and run no load for 2-3 minutes to cool the
motor.
When drilling in metal, only use HSS, Titanium or
Cobalt drill bits that are in good condition.
Always use a magnetic bit holder when using short
screwdriver bits.
Where possible use a pilot hole before drilling a
large diameter hole in metal material.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating
and changing accessories. Inspect tool cords
periodically and if damaged, have repaired by
authorized service facility.
Your power tool requires no additional lubrication or
RC3031K PDN500AU 060427.indd 8 2006-7-19 16:32:07