Rockwell ShopSeries RC3031K, Руководство пользователя

Страница: 4 / 24

4.5A HAND DRILL ENG
4
COMPONENT LIST
KEYLESS CHUCK
HORIZONTAL BUBBLE LEVEL
LOCK-ON BUTTON
FORWARD/REVERSE SELECTOR SWITCH
ON/OFF SWITCH
VARIABLE SPEED CONTROL
BELT CLIP
1
2
3
4
5
6
ACCESSORIES
drill bit 10pcs
(5/64”, 7/64”, 1/8”, 5/32”, 13/64”, 15/64”, 9/32”, 5/16”,
23/64”, 3/8”)
We recommend that you purchase your accessories
from the same store that sold you the tool. Use good
quality accessories with a well-known brand name.
Choose the type according to the work you intend
to undertake. Refer to the accessory packaging for
further details. Store personnel can assist you and
offer advice.
SAFETY INSTRUCTIONS
WARNING! READ AND UNDERSTAND ALL
INSTRUCTIONS. Failure to follow all instructions
listed below, may result in electric shock, fire and/or
serious personal injury.
SAVE THESE INSTRUCTIONS
1.WORK AREA
- KEEP YOUR WORK AREA CLEAN AND WELL LIT.
Cluttered benches and dark areas invite accidents.
- DO NOT OPERATE POWER TOOLS IN EXPLOSIVE
ATMOSPHERES, SUCH AS IN THE PRESENCE OF
FLAMMABLE LIQUIDS, GASES OR DUSTS. Power tools
create sparks which may ignite the dust or fumes.
- KEEP BY-STANDERS, CHILDREN, AND VISITORS AWAY
WHILE OPERATING A POWER TOOL. Distractions can
cause you to lose control.
2.ELECTRICAL SAFETY
- DOUBLE INSULATED TOOLS ARE EQUIPPED WITH A
POLARIZED PLUG (ONE BLADE IS WIDER THAN THE
OTHER. THIS PLUG WILL FIT IN A POLARIZED OUTLET
ONLY ONE WAY. IF THE PLUG DOES NOT FIT FULLY IN
THE OUTLET, REVERSE THE PLUG. IF IT STILL DOES NOT
FIT, CONTACT A QUALIFIED ELECTRICIAN TO INSTALL A
POLARIZED OUTLET. DO NOT CHANGE THE PLUG IN ANY
WAY. Double Insulation eliminates the need for the
three wire grounded power cord and grounded
power supply system. Before plugging in the tool,
be certain the outlet voltage supplied is within the
voltage marked on the nameplate. Do not use “AC
only” rated tools with a DC power supply.
- AVOID BODY CONTACT WITH GROUNDED SURFACES
SUCH AS PIPES, RADIATORS, RANGES AND
REFRIGERATORS. There is an increased risk of
electric shock if your body is grounded. If operating
the power tool in damp locations is unavoidable,
a ground fault circuit interrupter must be used to
supply the power to your tool. Electrician’s rubber
gloves and footwear will further enhance your
personal safety.
- DON’T EXPOSE POWER TOOLS TO RAIN OR WET
CONDITIONS. Water entering a power tool will
increase the risk of electric shock.
- DO NOT ABUSE THE CORD. NEVER USE THE CORD
TO CARRY THE TOOLS OR PULL THE PLUG FROM AN
OUTLET. KEEP CORD AWAY FROM HEAT, OIL, SHARP
EDGES OR MOVING PARTS. REPLACE DAMAGED CORDS
IMMEDIATELY. Damaged cords increase the risk of
electric shock.
7
RC3031K PDN500AU 060427.indd 4 2006-7-19 16:32:06