Chapter 7-6
Setting Robomow and using Advanced Features
7.2.7 Scan Width
Use the Scan Width option to change the mowing movement of Robomow.
This can be beneficial in some lawns.
P
If the mower is continuously moving back and forth along the same
path, it is recommended to increase scan width.
7.2.8 Enable Dock
Use the Enable Dock to switch ON the docking options menu of the Base
Station.
If Enable Dock is turned off, the docking options menus are hidden.
7.2.9 Eco mode
Use ECO (Economic) option to operate Robomow with the
minimum energy needed for cutting the grass and maintaining the
lawn.
Operation in ECO mode reduces Robomow noise level during
operation and allows longer operation periods.
As a default, the ECO mode is set ‘On’.
ECO mode will turn ‘Off’ automatically, increasing the power of the
mowing motors, for short periods of time, in areas or times when
mowing of high and dense grass is detected. Robomow will revert
back to ECO mode ‘On’ once this condition diminishes.
7.2.10 Signal Type
In some circumstances there may be interference to the wire signal
caused by other wire signal activated in adjacent lawn (neighbor that
use robotic lawnmower) or by any other appliance using similar
frequency. In case of signal interference, you may see one of the
following symptoms (usually close to the neighbor lawn):
a. Robomow is widely swinging when driving along the wire;
b. Robomow changes direction without reaching the wire;
c. Robomow crosses the wire outside the designated area;
d. ‘Start inside’ message is displayed although Robomow is inside
the designated area and the perimeter wire is connected in the
right polarity;
If your mower faced one of the above symptoms, to change the
signal type call to service.
Eco mode
Press GO
on
Press GO
off
Confirm
procedure part 7.2.10.FH10
