Chapter 4-2
Robomow City 120
4.3.2
Manual depart
Manual depart is used when mowing the lawn at UNscheduled times, or
when the lawn has to be cleared of people or debris before the scheduled
mowing starts.
)
To initiate manual start, press
once.
If you prefer to skip edge mowing,
press
twice
If Entry Points have been previously set, Robomow will ask you to select a
current entry point.
Robomow departs from Base Station and starts edge mowing: automatically
completes one loop around the Perimeter Wire and reaches back to Base
Station.
It will briefly start to dock, but then back up in order to mow the inner lawn.
Robomow automatically determines the entry point from the perimeter wire into
the lawn. A ‘Searching entry’ message is displayed on the Manual Controller
while it is searching for the entry point into the lawn.
4.4 Returning to Base Station
4.4.1
Robomow automatically returns to Base Station at the end
of mowing.
4.4.2
Manual “Go to Base” option
You can manually send Robomow to Base Station anytime and from
anywhere on the lawn.
)
Manual Controller should be in
its holder.
)
Make sure Base Station is
turned on.
)
Point Robomow toward any
Perimeter Wire section (but
NOT a Perimeter Island or
excluded obstacle).
)
Perform the following
sequence:
4.4.3
Manual Charging of Robomow with the Manual Controller
P
Drive the Robomow manually into the Base Station using the navigation
buttons on the Manual Controller.
P
Once in the station, reinsert Manual Controller
Adjust the controller and its coil until it is at level with top of Robomow
P
Confirm the display changes to a battery charging icon, indicating a
successful docking.
