13 • Start Up
03 Series Operator’s Manual
Press and release the POWER MODE button during this time to go
to the A--CAL or E--CAL menu item in Calibration Mode depending
on the value entered into the One Touch Cal Time parameter of the
03 Series User Setup Program. If no button is pressed, the
instrument will continue with the warmup sequence in Step 6 once
the sequence shown above has finished.
•
If calibration is not due, then the following screen appears for a few
seconds indicating when the next calibration is due. “NEXT” and
“CAL” alternate on the bottom of the screen.
NOTE:
The following screens in Step 6 only appear if Bump Test Limit
Display
is set to On using the 03 Series User Setup Program. The
standard factory setting for this function is Off.
6. If Bump Test Limit Display is set to Off (factory setting), proceed to
Step 8.
7. If Bump Test Limit Display is set to On using the 03 Series User Setup
Program, the next screen will depend on how Bump Test Limit Check
is set in Setup Mode or using the 03 Series User Setup Program.
•
If the unit is due for bump testing and Bump Test Limit Check is set
to Confirm to use (factory setting), then the following screen
sequence will occur.
CAL.
14. 2.17
180d
NEXT
14. 2.17
180d
BUMP
teSt
YES
NOW
teSt
MODE
BUMP
teSt
NOW
teSt
NO
BUMP
teSt
AIR
NOW
teSt
