Riverbed Cascade Express, Руководство по установке

Страница: 75 / 92

Cascade Installation Guide
65
9. Gateway installation
This section describes the hardware and software configuration necessary to
install a Gateway. Refer to Section 3 mounting instructions.
Configuration information
When you configure the Gateway, you will be asked to provide configuration
information. Information that is required to complete the installation is listed with
an asterisk (*) in the table that follows. Items not marked with an asterisk are
optional during installation and can be specified afterwards on the Gateway
Configuration  General Settings page if necessary.
It may be useful to write the configuration values in the blank column of the table
so that you can refer to them during the configuration step or afterward.
Gateway host name:*
Gateway IP address:*
Netmask:*
Default gateway:*
DNS name resolution for hosts (enable or disable):
Primary DNS server IP address:
Secondary DNS server IP address:
DNS search domain:
Management interface port settings:
10/100/1000 Mb/s, half- or full-duplex, or auto-negotiate
Switch port settings:
The settings of the switch port or hub that the Gateway management
port connects to.
Time Zone:
Flow encryption certificate (default or new certificate):
For faster installation, use the default encryption certificate shipped
with the Gateway and then generate a new certificate later.