Riverbed Cascade Express, Руководство по установке, Страница: 54 / 92

Cascade Installation Guide
44
Fifth Profiler data input address:
Password to use for your initial Sensor login:*
The default password
admin
.
New password to enter when prompted to change the
initial Sensor password:*
Applies only to systems not previously configured.
Remote Management Module IP address
Remote Management Module netmask
Remote Management Module gateway
Configuring the Sensor
The first time you log in to a newly-installed system, it displays an initial Setup
page. This is a one-time display. After you set up the initial configuration, you
can make subsequent configuration changes on the
Configuration pages of the
GUI.
To configure the Sensor, you need a separate PC and a crossover cable. This PC
must have an Ethernet port configured for TCP/IP networking. It must also be
running Mozilla Firefox or Microsoft Internet Explorer. The LAN interface
adapter settings of this PC must be set to:
•
IP Address: 192.168.1.30
•
Network mask: 255.255.255.0
•
Gateway: 192.168.1.1
Using these settings, connect to the Sensor as follows:
1. Use a crossover Ethernet cable to connect the Ethernet port of your PC to
the
Management connector on the left rear of the Sensor.