![background image](http://html1.mh-extra.com/html/riverbed/cascade-express/cascade-express_installation-manual_1465706045.webp)
Cascade Installation Guide
35
Network connections
After the Express is mounted, configured, and has been powered on for more than
two minutes, connect the network cable and verify the connections as follows:
1.
Connect the cable from your network to the
Management
connector on
the left rear of the Express. This is the same connector that you used to
configure the Express.
2.
If your Express is a flow-monitoring-only model, skip to Step 3 below. If
your Express is not a flow-monitoring-only model, then connect the cables
from the tap or mirror ports on the monitored networks to the network
monitoring ports, which are labeled
Mon0
and
Mon1
.
3.
Connect a cable from the network to the RMM connector on the right rear
of the Express. The RMM connection and the Express management
connection can be on different subnets, but these must correspond to the
addresses you assigned for each interface on the
Setup
page.
4.
Point your browser to the Express IP address that you specified on the
Setup
page during the
Configuration
task. This displays the login page.
Содержание Cascade Express
