Riverbed Cascade Express, Руководство по установке, Страница: 29 / 92

Cascade Installation Guide
19
5. Enterprise Profiler installation
This section describes the hardware and software configuration necessary to
install an Enterprise Profiler. Refer to Section 3 mounting instructions.
Configuration information
When you configure the Profiler, you will be asked to provide configuration
information. Information that is required to complete the installation is listed in
the table that follows with an asterisk (*). Items not marked with an asterisk are
optional during installation and can be specified afterwards on the Profiler
Configuration  General Settings page if necessary.
It may be useful to write the configuration values in the blank column of the table
so that you can refer to them during the configuration step or afterward.
Profiler host name:*
Profiler IP address:*
Netmask:*
Default gateway:*
DNS name resolution for hosts (enable or disable):
Primary DNS server IP address:
Secondary DNS IP address:
DNS search domain:
NTP server IP addresses:*
Applies only if Profiler is being synchronized to an external NTP
server. Enter one or more addresses as a comma-separated list.
Time Zone:
Flow encryption certificate (default or new certificate):
For faster installation, use the default encryption certificate shipped
with the Profiler and then generate a new certificate later.
Profiler Management Module IP address: *
If you will be changing from the default address of 192.168.1.10.
This setting was previously called the Management address.