Riverbed Cascade Express, Руководство по установке, Страница: 62 / 92

Cascade Installation Guide
52
Additionally, the Steelhead should have its SNMP ifIndex persistence feature
enabled. This is done on the Steelhead CLI. For example:
ssh admin@<
your SH
>
[In this example, the Steelhead is cam-sh12.]
cam-sh12 > en
cam-sh12 # config t
cam-sh12 (config) # snmp ifindex-persist
You must restart the optimization service, so that netflow can use
the configured ifindex
cam-sh12 (config) # exit
cam-sh12 # write mem
cam-sh12 # show snmp
SNMP enabled: yes
System location:
System contact:
Engine ID: 0x8000430b805dc6257f4b328d15
Read-only community: riverbed
Traps enabled: yes
Interface listen enabled: no
Trap interface: primary
Persistent ifindex: yes
No Listen Interfaces.
No trap sinks configured.
This helps maintain consistency in interface reporting on the Cascade Profiler or
Express that is receiving flow data from the Steelheads. This setting may be
impacted when you upgrade your Steelhead software.
Configuration information
Information that is required to complete the installation is listed with an asterisk
(*) in the table that follows. Items not marked with an asterisk can be specified
afterwards on the Sensor-VE
Configuration  General Settings page if
necessary.
It may be useful to write the configuration values in the blank column of the table
so that you can refer to them during the installation or afterward.
Sensor-VE name:
Sensor-VE management IP address:*
Sensor-VE management subnet mask:*
Sensor-VE management default gateway IP address:*
DNS name resolution for hosts (enable or disable):
Primary DNS server IP address:
Secondary DNS server IP address: