Operating Manual Version 7.3-03 of 28.07.20
29
7 MAINTENANCE SERVICE
The device shall be serviced and repaired only by the manufacturer.
8 TROUBLESHOOTING
8.1 If the device is not operating properly, identify the problem and
refer to the following trouble shooting chart for suggested solutions as
indicated in the following Table 4.
Table 4
Fault
Possible cause
Troubleshooting method
Some adjustments do not
work or the requirements
of p.5.4 are not fulfilled.
Processor mal-
function.
Switch off the device, and in
5-10 sec switch it on again.
Check whether the require-
ments of p.5.4 are fulfilled.
If the problem persists, contact
the manufacturer.
The SCENAR device
emits 5 short beeps from
time to time.
The picture on the LCD
disappears or is distorted
from time to time.
The SCENAR device fails
to switch ON.
The batteries are
discharged or set
incorrectly.
Check and replace the batter-
ies.
If the problem persists after
the batteries are replaced,
contact the manufacturer.
The SCENAR device op-
erates but there is no en-
ergy on the built-in elec-
trode.
The protective
film is not re-
moved from the
built-in elec-
trode.
The energy level
is too low.
Remove the protective film
from the built-in electrode.
Increase the energy level until
comfortable sensations appear.
