Operating Manual Version 7.3-03 of 28.07.20
16
pressed within 2 seconds, the device will switch to the
‘B’ state,
or, if
any dosing is on, the device will switch to the
Dose state.
To activate the dosing, set the
Dose
parameter to
1, 2, 3, 4
, or
5
in the menu.
In this state pressing the
+
and
–
buttons switches the device to the
‘B’ state
to control the energy value (the device will return to the
Dose
state
if no buttons are pressed within 2 seconds).
To switch the device to the
Menu state
, use the button
.
6.1.3 The device supports 4 screen orientations: 2 landscape modes
(Fig.19a) and 2 portrait modes (Fig.19b). To change the screen orienta-
tion, press the
button in the
‘B’ state
or in the
Dose state.
a
b
Fig.19
6.1.4 There is a battery indicator in the top line of the screen. The
degree of its infill shows the battery’s charge. If the indicator is blank,
remove
all 4 batteries and install 4 new ones
.
6.1.5 When switching on the device, the following parameters are set:
the energy strength of stimulus is set to the minimum set-
ting (
1
);
dosing is switched off (
Off
);
amplitude modulation is switched off (
Off
);
frequency modulation is switched off (
Off
);
stimulus frequency is set to
90.7
Hz;
damping is switched off (
Off
);
intensity is set to the minimum setting (
1
);
gap between stimuli in a burst is set to the minimum value (
10
).
