Operating Manual Version 7.3-03 of 28.07.20
26
6.2.7 Setting the Stimulus Gap in a Burst (
Gap
)
To control the gap
,
you can either press the buttons ‘step by step’ or
press and hold the appropriate button (this way is faster).
At
Int 1
, the
Gap
parameter has no sense, though it can still be
controlled, and then, when you will be increasing the intensity, the device
will use the set value of the gap.
6.2.8 Switching Off the Device
To switch off the device, use the switch button on the lateral surface of the
case. The settings are NOT SAVED after switching off but you can save your
5 sets of parameters
in the flash memory of the device (see p. 6.3.6).
6.2.9 Switching the Device to the Standby Mode
To switch the device to the standby mode, press simultaneously the
buttons
and
. To resume operation, press the button
.
6.3 SERVICE MENU
The device has a
Service menu
state
(Fig.28).
To enter the Service menu, press the buttons
and
+
simultane-
ously, and a rising beep will sound. Optionally, devices may have an ad-
ditional way to enter service menu by pressing and holding
button.
The parameters of the Service menu are selected and set in the same way
as in the main Menu (to select a parameter, use the buttons
and
,
and to set the required value, use the buttons
+
and
–
). When no buttons
are pressed within 2 seconds, the device switches to the previous state,
and the
value of the highlighted parameter
(and this value solely) is
saved in the flash memory of the device. If the value has been changed,
then a descending beep will sound.
Fig.28
So, within the same menu entering, you can
change any number of
parameters but only one parameter will be saved.
