Riso RZ200AW, Руководство пользователя

Страница: 85 / 112

Troubleshooting
Check & Error Display
82
3
A-02
A master has not been correctly
wrapped around the Print
Cylinder(Drum).
B
Caution:
• The Print Cylinder(Drum) is equipped with
many metallic components. Touch the Print
Cylinder(Drum) only when necessary. These
components may cut your fingers.
• When turning the Print Cylinder(Drum) with
hand, hold the edge of the Print
Cylinder(Drum). If you push on the master,
your fingers may be smudged with ink.
• The Clamp Plate opens while the Clamp Plate
Release Lever is pressed. Be careful that your
fingers will not be caught and hurt.
• The seperated master is covered with ink. Be
careful that the master will not contact with
other objects.
A-04
A master has not been sent to the
Master Disposal Box.
1)
Pull out the Print Cylinder(Drum) and
remove the master on the cylinder(drum).
) p.73
2)
Set the Print Cylinder(Drum) again.
3)
Press the key.
A-16
An unnecessary master remains on
the Print Cylinder(Drum).
1)
Perform actions 1) through 5) provided for
error No. “A-02”.
) p.81
2)
Perform the master-making operation again.
J-04
A paper jam has occurred around
the Print Cylinder(Drum).
1)
Pull out the Print Cylinder(Drum).
) p.73
2)
If you find jammed paper, remove it.
B
Caution:
• When putting your hand into the machine to
remove paper, do not touch the paper
separation hook. The sharp tip of the hook
may hurt your hand.
Location
No.
Error No. Cause Action
Troubleshooting
Check & Error Display
83
4
A-01
A-34
A master has not been correctly set. Open the Master Making Unit Cover, remove the
master roll, and set the master correctly. If the
master is loose, turn the right flange inward to
correct it, and close the Master Making Unit
Cover.
) p.68
A-17
A master has not been correctly cut.
1)
Remove the master roll and close the
Master Making Unit Cover.
2)
Set the master again.
) p.68
5 A-05
A master jam has occurred in the
master disposal section.
1)
Remove the Master Disposal Box.
2)
Stand at the side of the Paper Feed Tray
and push down the Master Disposal Roller
Release Lever at the inside right.
3)
Remove the master jammed on the roller
section.
4)
Push the Master Disposal Roller Lock Lever
inward.
5)
Set the Master Disposal Box.
) p.71
6 J-08
A paper jam has occurred on the
Paper Feed Tray section.
1)
Remove the jammed paper.
2)
Set paper again.
3)
If the error indications do not disappear,
press the
key.
Location
No.
Error No. Cause Action
Riso Kagaku Technical Training Center Version