Riso RZ200AW, Руководство пользователя

Страница: 26 / 112

Safety Guide - Handling and Operation
24
Basic Operations
Safety Guide - Handling and Operation
This section describes the precautions to be observed when handling the machine. Read this section before operat-
ing the machine.
Operation Environment
Important!:
• Operate the machine under the following appropriate environment conditions.
Temperature range: 59
°
F to 86
°
F(15
°
C to 30
°
C)
Humidity range: 40% to 70% (noncondensing)
Machine Handling
A
WARNING:
• Do not place water containers or metallic objects on the machine. Fire or electric shock may occur if water or metal-
lic objects fall into the machine.
• Do not insert any metallic material or flammable substance into the machine through any opening. This can result
in fire or electric shock.
• Do not remove machine covers. Exposing internal parts may result in electric shock.
• Do not disassemble or rebuild the machine by yourself. This can result in fire or electric shock.
• If the machine emits excessive heat, smoke or foul odor, immediately turn off the POWER, unplug the electric cord
and contact your service representative. Failure to do so can result in fire or electric shock.
• If something drops inside the machine, immediately turn off the POWER, unplug the electric cord and contact your
service representative. Failure to do so can result in fire or electric shock.
• Never stick your hands or fingers in the openings of the machine during operation.
• Keep loose clothing or long hair away from moving parts to avoid becoming entangled.
• Do not place heavy objects on the machine. The objects might fall and cause injury.
• Contact your service representative before moving the machine.
B
Caution:
• Do not open any covers or move the machine during operation.
• Unplug the electric cord, if you do not use the machine for a long time.
• The machine has precision parts and driving parts inside. Do not handle the machine in other ways than described
in this guide.
• Do not apply any shock to the machine.
Important!:
• Do not unplug the electric cord or turn off the power during operation.
• Be sure to open and close all machine covers gently.
Before Starting to Use
Preparing to Print
21
Setting up the Paper Receiving Tray
1
Open the Paper Receiving Tray.
2
Position the Receiving Tray Paper
Guides.
Raise the guides, hold their lower parts, and then
slide them according to the width of paper.
Important!:
• For thick paper such as drawing paper, position
the Receiving Tray Paper Guides a little wider
than the actual paper width.
• When you move the Paper Feed Tray using the
Horizontal Print Position Adjustment Dial, repo-
sition also the Receiving Tray Paper Guides. If
the guides are not correctly positioned, a prob-
lem such as a paper jam can occur.
3
Raise the Paper Stopper, and then
slide it according to the length of
paper.
The subsequent steps differ depending on the
models.
• For RZ3XX, go to step 4.
• For RZ2XX, go to step 6.
4
Adjust the Paper Arrangers.
(For RZ2XX, unavailable)
Alignment of paper is affected by sizes and
strength of paper. Adjust the Paper Arrangers so
that printed paper is aligned.
z
For ordinary paper
Press to open all of the four Paper Arrangers.
Riso Kagaku Technical Training Center Version