Risco LightSYS, Инструкция по установке и программированию

Страница: 92 / 228

Engineer Programming
Page 92
Quick Keys Parameter
Default Range
unsetting using the keypad, the related partitions will be unset. In
order to set the partition using the keyswitch again, turn the key to
the unset position and then to the set position.

If a keyswitch latch is assigned to more than one partition and one of
the partitions is set by using the keypad (the keyswitch stays in the
unset position), then:

When changing the position of the keyswitch to the set position,
all the unset partitions, which belong to this keyswitch, will be
set.

When turning the keyswitch to the unset position, all the
partitions will be unset.

ZZ

Entry Fo Part Set
All
Assigned to motion detectors and to interior doors protecting the area
between the entry door and the keypad, as follows:

In PART SET (SET) mode, a zone(s) given this designation behaves
like an Exit/Entry zone and is subject to the Entry and Exit Delay
time periods specified under Exit/Entry Delay 1. (Refer to Exit/Entry
Delay 1, page 85.)

In FULL SET mode, a zone(s) given this designation behaves like an
Entry Follower Zone and causes an immediate intrusion alarm when
violated unless an Exit/Entry zone was violated first.

If so, an Entry Fo Part Set zone(s) remains omitted until the
end of the Entry Delay period.

ZZ

Pulsed Keyswitch Delay
Used to apply the Exit/Entry Delay 1 parameter to the momentary
keyswitch operation. (see

ZZ

above
)

ZZ

Latch Keyswitch Delay
Used to apply the Exit/Entry Delay 1 parameter to the latched keyswitch
operation. (see

ZZ

above
.)

ZZ

Tamper
For tamper detection. This zone operates the same as 24 hours zone, but
it has a special reporting code.