K-FACTOR (FLOW FACTOR)
The NoNa
+
is equipped with two flow sensors. The 'K-factor' (pulse/litre) has
been set for both sensors.
The K-factor is set to 128.45 by default (the tube diameter in which the
flow sensors are located is 20 mm (DN 15)).
To set the K-factor, navigate this path:
.
Figure 5-7:
The K-factor (flow factor) set
5.3.5
Sodium removal
Before you can start using the sodium removal unit, you need to enter the settings for
the following:
Purification
Short flush with fresh water
Intermittent (acid) cleaning
Start conditions.
The
Preset values
setting is set to 'Yes' by default. This means that some
settings for purification, short flush with fresh water and intermittent (acid)
cleaning have already been set to appropriate values. For more information,
please see "Advanced settings" on page 55.
More information about using and setting up the sodium removal unit can be found in
the section "Operating the HortiMaX-Go! (NoNa+)" on page 51.
5.4
Calibrating the sensors
The EC sensors need to be checked regularly in order to ensure accurate
measurements. This must be done at least once per year.
The calibration process requires special calibration solutions. To calibrate the EC
sensor, you need EC 1.4 and 5.0. The order in which the solutions need to be used is
fixed and may not be reversed.
NoNa
+
46
Содержание NoNa+
