Ridder NoNa+, Инструкция по установке и эксплуатации

Страница: 17 / 72

No. Name No. Name
1 Desalination box including stack 11 Wastewater
outlet
2 EC sensor (drain water before the stack) 12 Drain water
inlet
3 EC sensor (drain water after the stack) 13 Active carbon
filter
(optional)
4 Sampling valve before the stack 14 Wastewater
tank
5 Wastewater pump 15 Fresh water
tank
6 Drain water pump 16 Dosing pump
for continuous
(acid)
cleaning
7 Emergency stop / Power switch 17 Dosing pump
for
intermittent
(acid)
cleaning
8 Control cabinet 18 Ring filter, 10
microns
9 Sampling valve after the stack 19 Wastewater
flow sensor
10 Drain water outlet
The number of valves depends on the number of drain
water tanks. In this figure, there are four outlet valves
and that means there are four drain water tanks.
If there is one outlet, a manual valve is used; if there
are multiple outlets, electric valves are used. (The same
applies to the drain water inlet.)
20 Ring filter, 55
microns
(optional)
21 Drain water
flow sensor
The following table provides an overview of the main specifications of the NoNa
+
basic configuration(s):
Component Specifications
Membranes in CED stack NoNa
+
10: surface area 400 [cm
2
], 48
cell pairs.
NoNa
+
20: surface area 1000 [cm
2
], 48
cell pairs.
NoNa
+
40: surface area 1000 [cm
2
], 96
cell pairs.
Sodium removal per treatment At least 20%
NoNa
+
17