Ridder NoNa+, Инструкция по установке и эксплуатации

Страница: 37 / 72

4.6 Installing other components
During the initial installation and commissioning of the NoNa
+
, the components listed
below will usually already be connected. However, it is also possible to add and
connect these components to the NoNa
+
later.
Before connecting components such as a sensor or ring filter, make sure that
the NoNa
+
is switched off.
4.6.1 Connecting level sensor
The NoNa
+
is stopped by a low-water float in the drain water tank. The NoNa
+
may
start when the water level is higher than the low-water float.
Connect the level sensor according to the wiring diagram.
Then check that it is operating properly:
Lower the low-water float into the water: the NoNa
+
should start running.
The Purification period active setting must be set to 'Yes'. To do this,
navigate this path: .
Remove the low-water float from the water: the NoNa
+
should stop running.
Always check that the float is sending the corresponding start or stop signal.
4.6.2 Connecting EC sensor
Two EC sensors can be connected to the NoNa
+
.
To connect a new EC sensor, complete the following steps:
1. Make sure that there is no water pressure in the NoNa
+
.
2. Connect the wiring according to the included wiring diagram.
3. Calibrate the sensor. See section "Calibrating the sensors" on page 46 for
explanation.
4. Unscrew the sealing cap at the location where you want to position the sensor.
5. Insert the sensor into the hole.
You can find more information in the OEM manual provided with the EC sensor.
4.6.3 Connecting ring filter
To connect a new ring filter, complete the following steps:
1. Unscrew the couplings.
2. Install the filter.
3. Screw the couplings back on.
Make sure that the filter is correctly positioned in relation to the flow
direction.
NoNa
+
37