北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd.
47
Forging ahead, create future together!
5.7
Additional parameters introduction
1)
Pulse equivalent calculation
：（
MACHINE SETUP
）
Rotary axis (pul/ °), formula = pulses per revolution / angles per revolution
（
360°
）
2)
Work origin offset
：
（
AUTO PRO SETUP, Unit
：
mm
）
For Z axis work origin which locates in the center of a material or not at the surface of
the material
，
then user can set the Z axis origin offset value. For example
：
A rectangular
wooden pillar, its work origin is at the center, however, the normal work origin can only
be set on the material surface, thus we use the “Work origin offset” function. The offset
can be a positive value or a negative value. If Z axis moves down, it should be a negative
value; If Z axis moves up, it should be a positive value. For X, Y and A axis work origin
offset value is set in the same rule.
3)
Rotary axis mark
：
(SYSTEM SETUP-Function Confi)
The user can choose a name for the rotary axis, there are 3 options can be selected
from this menu: A/B/C, modify as required. After that the system requires a reboot.
5.8
Programming example
%
G54
G90 G17
T1M6
S1200M3
G0 Z98.500
X-640.000 Y9.369 A0.000
G01 F9000
