北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd.
66
Forging ahead, create future together!
3)
Too much interference in the Z-axis homing process to form a false Z origin. Re-adjust the
wiring.
The machine cannot stop after returning ZERO, and cause spindle hit the machine body
Double press“
”to check input signal (Origin detection switch signal). To do self test.
Detect whether the signal is triggered or disconnected.
1)
The origin detection switch is broken. Replace a new one.
2)
The distance of the origin detection switch detection sheet beyond the detection range(This
problem is common occurs in optoelectronic and proximity switches) of the switch, adjust
the position of the test piece.
3)
The origin detection switch to the interface board wiring aging or loosening. Check the
connections again.
4)
The interface board is broken. Return back to us to repair.
5)
50-pin data cable is broken. Replace it with a new data cable.
The machine uniform moves to the reverse direction when backing to the machine ZERO
1)
The origin detection switch types do not match with the definition of the corresponding
voltage level. Modify the voltage level in the controller. (Normally open type corresponds to
a level defined the direction of the arrow down, normally closed type corresponds to the
level defined arrow up).
2)
The origin detection switch is broken. Replace a new one.
3)
The origin detection switch connects interface board not well. Refresh the cable to confirm
the wiring is correct.
4)
Too much interference, resulting in the illusion of the detection switch has been
triggered. Recalibrated the whole circuit.
5)
The interface board is broken. Depot Repair.
6)
50-pin data cable is broken. Replace the data cable.
