北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd.
21
Forging ahead, create future together!
Too high, it will cause the motor losing steps, jitter and even whistle; Set too small, it will reduce
the operating speed of the entire graph.
If the inertia of motion axes is heavy (shaft very heavy), can set a smaller starts peed; if the inertia
of motion axes is light (shaft very light), can increase the start speed value.
Voltage Setup
Used to set the input, output signal port normally open or normally closed port state, system
defines “
↓
” as normal open; “
↑
” as normal closed.
Including 2 rows of arrows
：
The upper arrows indicate the input level definition
：
Set input signal terminal status definition.
The first four:
0,1,2,3
are
X
axis HOME,
Y
axis HOME,
Z
axis HOME,
A
axis HOME; The 5 to 8
positions are:
4,5,6,7
correspond tool setting, driver alarm, E-stop signal and foot switch input
signals.
The under arrows indicate the output level definition
：
Set output signal terminal status definition.
The top four: 0
、
1
、
2
、
3 correspond to
spindle On/Off
,
multi-speed 1
,
multi-speed 2
,
multi-speed
3
output signals; The 5 to 6 positions are:
4, 5
correspond
alarm lamp, run lamp
output signals.
Setting
：
Press “
and
” move to left or right in the row. Press“
and
” can jump up and down. Move the cursor to arrow which needs flip, and press
“
” to flip the arrow.
C.A.D. Thickness (Unit: mm)
The thickness should input actual value. If the input value is bigger than the actual thickness, Z
axis may over cut; if smaller, Z axis tool bit can’t reach workpiece surface. This parameter can only
take effect when user uses auto tool setting function. Invalid when manual set workpiece origin
(press XY
→0, ZC→0
).
Max Spd Limit (Unit: mm/min)
Set the maximum movement speed of three axis positive and negative direction, the setting is
