Reson SeaBat 8160, Руководство оператора

Страница: 16 / 129

SYSTEM COMPONENTS
SeaBat 8160
Operator‟s Manual
Page 6 October 6, 2011
Version 5
Figure 2: Sonar Processor Rear Panel
2.3 Transceiver Unit
The transceiver unit contains the system transmitter and receiver boards and is
responsible for the following functions:

Generates a synthesized calibration signal at power-on and injects it into
the receivers for use by the sonar processor.

Generates the transmit pulse and sends it to the projector array.

Receives reflected acoustic pulses from the receive array.

Amplifies, band-shifts, and multiplexes hydrophone signals, then sends
them to the sonar processor via the signal and control cable.
NOTE
The only operator control on the transceiver unit is the On/Off power isolation
switch on the rear panel. Once this switch is set to “On,” all power is controlled
by the sonar processor.
2.3.1 Technical Specifications
The technical specifications of the transceiver unit are listed in Table 3 .
Table 3: Transceiver Unit, Technical Specifications
Specification Value
Power Requirements 24VDC (from sonar processor)
Mounting 19-inch rack