Raven viper, Инструкция по установке и эксплуатации

Страница: 78 / 182

C
HAPTER
8
70 Viper/Viper 4+ Installation & Operation Manual
5. Select:
•
“Two Wheel Cart” type to create a new single axle profile from scratch.
•
“Four Wheel Cart” type to create a new double axle profile from scratch.
•
“Pull-Type Toolbar” type to create a new pull-type toolbar from scratch.
•
“Mounted Toolbar” type to create a new mounted toolbar from scratch.
•
an existing implement profile to clone the profile settings for the new implement
6. Use the on-screen keyboard to enter the name for the new machine profile and touch the Done button. If a
new implement type is selected, proceed to step 7. If using an existing implement profile to create the new
profile, skip to step 10.
7. The machine profile selection prompt will display if creating a new machine profile from scratch.
8. Use the drop down selections to set the implement profile type, sub-type, manufacturer, and model (if
available) of the implement to be created.
9. When the appropriate selections are set, touch the OK button.
10. The General Information tab allows the operator to enter or modify implement information. Touch the
information fields and use the on-screen keyboard to enter general information about the implement for
identification purposes. If a preset implement profile was selected, verify the information displayed and make
adjustments if necessary.
11. Enter the front and rear (if applicable) tongue and hitch length measurements for the implement. Refer to
General Information Tab section on page 77 for assistance with measuring these values.
12. Press Next.
13. Review the displayed section information. If a preset implement profile was selected, the section information
for the equipment available from the manufacturer will be set for section groups as appropriate. Touch the:
•
Delete button to remove section groups from the implement profile.
•
Edit button to modify sections labels, widths, or offset information.
•
Add button to create a new or customized section group.
Refer to Section Groups and Section Settings section on page 72 for more information on setting up
implement section groups.