Rauch AXENT 100.1, Дополнительные инструкции

Страница: 105 / 114

No. Message in display Meaning and possible cause
17 Error by setting drop point The drop point adjustment cannot reach the
specified target value.
• Fault, for instance with the power supply
• No position feedback
18 Error by setting drop point The drop point adjustment cannot reach the
specified target value.
• Blockage
• No position feedback
• Calibration test
19 Defect by setting drop point The drop point adjustment cannot reach the
specified target value.
• No position feedback
20 Error at LIN bus participant: Communication problem
• Defective cable
• Loose plug connector
21 Spreader overloaded! For weighing spreader only: The mineral
fertilizer spreader is overloaded.
• Too much fertilizer in the hopper
22 Unknown condition Function-Stop Communication problem with terminal
• Possible software error
23 Error by setting TELIMAT The TELIMAT adjustment cannot reach the
specified target value.
• Blockage
• No position feedback
24 Defect by setting TELIMAT Defective TELIMAT actuator
25 Activate disc start. Confirm with ENTER
26 Discs started up without activation Defective or manually switched hydraulics
valve
27 Discs started up without activation Defective or manually switched hydraulics
valve
28 Disc could not start up properly. Deactivate disc
start.
Spreading discs do not rotate.
• Blockage
• No position feedback
7. Alarm messages and possible causes
AXENT ISOBUS 5901646
105