Rauch AXENT 100.1, Дополнительные инструкции

Страница: 23 / 114

3 Attachment and installation
3.1 Tractor requirements
Before installing the machine control unit, ensure that your tractor meets the following requirements:
•
A minimum voltage of 11 V must always be guaranteed, even if multiple loads are connected
simultaneously (e.g., air conditioning system, lights)
• The PTO speed can be set to 1000 rpm and has to be complied with.
On tractors without load-switchable transmission, the forward speed must be selected by
using the correct gear ratio in such a way that it corresponds to a PTO speed of
1,000 rpm .
• 9-pin socket (ISO 11783) located at the rear of the tractor, for connecting the machine control unit
to the ISOBUS
• 9-pin terminal plug (ISO 11783) for connecting an ISOBUS terminal to the ISOBUS
The power supply of the machine control unit is implemented via the 9-pin ISOBUS socket at the rear
of the tractor.
If the tractor is not equipped with a 9-pin socket at the rear, a tractor assembly set including a 9-pin
socket for the tractor (ISO 11783) and a forward speed sensor may be purchased additionally as
special equipment.
• The tractor has to provide the speed signal to the ISOBUS.
Check with your dealer that your tractor is equipped with the required connections and sockets.
• Due to the numerous configurations of tractor/machine/terminal, please contact your dealer
for selecting the correct connection.
3.2 Connections, sockets
3.2.1 Power supply
The power supply of the machine control unit is implemented via the 9-pin socket at the rear of the
tractor.
3.2.2 Connecting the machine control unit
Depending on the equipment, there are different methods for connecting the machine control unit to
the mineral fertilizer spreader. Further information can be obtained from the operator’s manual of your
machine.
3. Attachment and installation
AXENT ISOBUS 5901646
23