R&S NRX Series, Руководство пользователя

Страница: 26 / 514

Getting Started
R&S
®
NRX
26 User Manual 1178.5566.02 ─ 07
Further information:
●
"Going back to a higher hierarchy level" on page 31
●
Chapter 4.3.2, "Returning to Manual Operation (LOCAL)" , on page 42
Screenshot
Creates a screenshot of the current display.
See Chapter 4.1.8, "Creating and Saving Screenshots" , on page 40.
Remote command:
SYSTem:HCOPy
on page 219
[1Trig] / Delete
●
Controls the measurements depending on the trigger mode:
–
For all trigger modes except "Single", starts and stops the measurement.
– For the "Single" trigger mode, enables and triggers the measurement.
Changes of the trigger state apply to all measurements.
See also
"Trigger Mode" on page 62.
●
Resets the auxiliary values that provide additional information about the measured
values.
See also
"Auxiliary Values" on page 51.
●
Deletes numbers or text in a field so that you can enter a new value.
Enter
●
Confirms entries in text fields, dialogs and selections in lists.
●
Shows a frame around the control in focus. You can change the focus using the
Cursor keys .
[Freq]
Sets the carrier frequency of the applied signal. This value is used for frequency-
response correction of the measurement result.
Remote command:
[SENSe<Sensor>:]FREQuency[:CW]
on page 319
Favorites
Reserved for future use.
[Preset]
Opens the "Save / Recall / Preset" dialog.
See Chapter 9, "Saving and Recalling Settings" , on page 132.
If you press [Preset] again, the preset function starts.
See "Preset" on page 133.
If you press the [Preset] key during booting, the R&S NRX starts with the factory
default state.
[Zero]
Pressing [Zero] opens the "Zeroing Sensors" dialog.
If you press [Zero] again, "Zero All Sensors" starts.
Instrument Tour
www.allice.de Allice Messtechnik GmbH