Beyond.the.Basics
Additional.Information
Installing.the.Belt.Clip
To.attach.the.belt.clip.
Insert the belt clip into the holes on each side
of the handset. Press down until it clicks.
To.remove.the.belt.clip
Pull both sides of the belt clip to release the
tabs from the holes.
Installing.the.Optional.Headset
You can connect an optional headset with a
3
/
32
-inch (2.5-mm)
plug. Contact your local
RadioShack
store for a suitable headset.
To connect the headset, open the rubber cover on the side of the
handset. Then insert the headset’s plug into the jack.
when you finish using the headset, disconnect it from the
handset and close the rubber cover to protect the jack.
NOTES
If you place the handset on the cradle to recharge
it while the headset is connected, be sure the
handset seats properly.
You can use a handset holder (available from
your local
RadioShack
store) to hang the handset
on your belt for greater convenience when using
a headset.
•
•
UC050ZH_43-164_OM3.indd 53
1/9/2007 3:46:01 PM
