1260-00C User Manual
Local Command Set 4-20
Example:
Get self-test status for device at Logical Address
48.
StatusState? 48
Dynamic
Configuration
Commands and
Queries
The dynamic configuration (DC) commands and queries are
described in the following paragraphs.
•
DCBNOSend
•
DCGrantDev
•
DCSystem?
The DC commands are used to configure the VXI system when all
of these conditions are present:
•
The 1260-00C is the RM.
•
At least one DC device is present in the system.
•
The non-volatile configuration setup specifies not to send
Begin Normal Operation (user-specified hierarchy).
•
The system is still in the start-up Configure substate
(DCBNOSend has not been sent).
The
DCSystem?
query response indicates whether the system
contains a DC device. If the system is found to be a DC system,
the
DCGrantDev
command is used to configure the
Commander/Servant hierarchy. The
DCBNOSend
command is
used to end the DC phase and to cause the system to enter
normal operation.
DCBNOSend
Purpose:
Cause a DC system to exit the Configure substate
and enter the Normal Operation substate.
Command
Syntax:
DCBNOSend
Action:
Send the Begin Normal Operation command to all
top-level Commanders.
DCGrantDev
Purpose:
Grant a device to a Message-Based Commander in
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com