ProLinx 6202-WA-DFNT-DFCM3, Руководство пользователя

Страница: 41 / 190

Configure the Module 6202-WA-DFNT-DFCM3 ♦ ProLinx Gateway
Wireless EtherNet/IP to DF1 Master/Slave-3 ports
ProSoft Technology, Inc. Page 41 of 190
February 2, 2009
[DF1 Port 1 Command]
START
# DF1 Port 1 Commands SLC500 2 Address Fields
# Enable Int Poll Reg Swap Node Func File File Elem Comment
Addr Intr Count Code Addr Code Type Num Num
1 1 50 1 50 0 1 509 N 7 50 # Write to cLX
END
2.5.10 [DF1 Port x]
The following shows a sample DF1 Port x section of the configuration file.
[DF1 Port x]
Enabled : Yes # Y=Use port, N=Do not use port
RS Interface : 0 # 0=RS-232, 1=RS-485, 2=RS-422
Type : Master # M=Master, S=Slave
Local Station ID : 0 # DF1 node address
Protocol : F # F=Full-Duplex, H=Half-Duplex
Termination Type : CRC # B=BCC, C=CRC
Baud Rate : 19200 # Baud rate for Port 110-38400
Parity : None # N=None,O=Odd,E=Even,M=Mark,S=Space
Data Bits : 8 # 5, 6, 7 or 8
Stop Bits : 1 # 1 or 2
Min Response Delay : 0 # 0-65535 mSec before sending response msg
RTS On : 0 # 0-65536 mSec before message
RTS Off : 1 # 0-65536 mSec after message
Use CTS Line : No # Use CTS modem control line (Y/N)
Response Timeout : 1000 # Response message timeout (0-65535 mSec)
Retry Count : 3 # Response failure retry count
ENQ Delay : 10 # 0-65535 mSec before DLE-ENQ sent
Minimum Command Delay : 10 # Minimum number of msec's between commands
Error Delay Counter : 100 # 0-65535 Command cycle count if error
Command Control Reg : -1 # Cmd control start DB Reg (-1=ignore)
First File : 7 # First file number for SLC simulation
File Size : 200 # Number of elements in each file
File Offset : 0 # Database offset for first file element
Modify each of the parameters as follows based on the needs of your application:
Enabled
This parameter specifies if the port will be used. If the parameter is set to No, the
port is disabled. If the parameter is set to Yes, the port is enabled.
RS Interface
1 = RS-232
2 = RS-422
3 = RS-485
This parameter is used when Ports 1, 2, 3 are present to configure the electrical
interface for the individual ports.
Port 1 must be jumper selected on the back of the unit.