Operating instructions SPEEDY 4all & 4you & 4teen
39
Figure 107: Both footrest parts folded up and
pivoted outwards
To
remove
the footrest parts, place the locking
pin lever vertical to the bracket towards the
front on both sides and then pull both footrest
parts upwards out of the bracket.
Figure 108: Locking pin lever for removing the
swing-away footrest
Figure 109: Swing away footrest removed
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 4 mm) must
be undone on both sides. The support tubes
are then pushed along their slots and thus, in
the correct position. Take care that the support
tubes have the same length on both sides after
the setting.
Figure 110: M6 fixing screw with washer for
adjusting the lower leg length
Once the position has been set, fix the support
tubes by tightening the M6 fixing screws
(AF 4 mm) with washers to 7 Nm on both
sides.
M6 fixing screws
with washer
Move the locking
pin lever vertical
to the bracket
Locking pin lever
