PRO ACTIV 4you EVOSPEEDY 4teen, Инструкция по эксплуатации и сервисная книжка

Страница: 50 / 76

Operating instructions SPEEDY 4all & 4you & 4teen
49
Figure 143: Brake element after correct positioning
of the integral brake
5. Tighten the M5 clamp screw (AF 4 mm) to
4 Nm again and, where applicable, the M6
clamp screw (AF 5 mm) to 10 Nm. Then
also, where applicable, screw the M6 grub
screw (AF 3 mm) back in until it rests
against the product frame.
6. Then check the correct setting of the
brakes: In the closed position,the brake
element presses the tyre in by approx. 4
mm.
25.3 Stop Lock hub brake
25.3.1 Opening and closing the brake
Opening and closing of the Stop Lock hub
brake on the right and left side is carried out by
pushing over the red actuating lever on the
drive wheel hub.
In the open position , both brake pins are in a
higher position and protrude approx. 2 cm
beyond the drive wheel hub.
Figure 144: Opened position
Figure 145: Brake pins in high position
In the closed position , both brake pins are in
a lower position and protrude approx. 1 cm
beyond the drive wheel hub.
Figure 146: Closed position
Figure 147: Brake pin in low position
Please note that the Stop Lock hub brake
is a parking brake which may only be applied
when the product is at a standstill. This is not a
service brake which is suitable for reducing
speed.
•
approx. 4 mm
Brake pin in high position
Brake pin in
low position