Operating instructions SPEEDY 4all & 4you & 4teen
34
Figure 87: M6 fixing screws on the frame outer side
4. Using the aid of the angle, move the caster
wheel bearing block in a vertical position to
the level ground.
5. Tighten the M6 fixing screws (AF 5 mm) on
the frame outer and
inner side back to a tightening torque of
10 Nm (do not forget the M6 washer
DIN134!) and check the vertical setting
again.
6. Screw the M5 stub bolt (AF 2.5 mm) back
in so that this rests on the M& fixing screw.
23 Foot rests
Measures need to be taken to ensure
there is sufficient ground clearance under the
footrest. Experience shows that this should not
be less than 4 cm. This must be observed for
the angle adjustment of the footplate and when
setting the lower leg length.
23.1 Angle adjustment of the footplate
The
angle
of the
footplate
can be set by
undoing the M6 fastening clamp screws
(AF 5 mm) on the bottom side of the footrest.
When the angle adjustment is completed,
tighten the M6 fastening clamp screws
(AF 5 mm) again to maximum 5 Nm. This
tightening torque should not be exceeded as
higher tightening torques can damage the
clamp.
Figure 88: Footrest from below
23.2 Footrest continuous
Figure 89: Footrest continuous
For the
longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length
, the M6 fixing screws (AF 4 mm) must
be undone on both sides. The support tubes
are then pushed along their slots and thus, in
the correct position. Take care that the support
tubes have the same length on both sides after
the setting.
M6 fixing screw
Footrest
Footrest
support plate
M6 fastening
clamp screws
