Operating instructions SPEEDY 4all & 4you & 4teen
36
When you fold the footrest back down, take
care that the recesses are resting accurately at
the back and front on the cylinder pins of the
bracket.
Figure 95: Cylinder pin and corresponding recesses
For the longitudinal setting of the footrest
support tubes or adaptation to the lower leg
length, the M6 fixing screws (AF 10 mm) must
be undone on both sides. The support tubes
are then pushed along their slots and thus, in
the correct position. Take care that the support
tubes have the same length on both sides after
the setting.
Figure 96: M6 fixing screw with washer and slots in
the support tube for adjusting the lower leg length
Once the position has been set, fix the support
tubes by tightening the M6 fixing screws (AF
10 mm) with washers to 7 Nm on both sides.
23.4 Footrest, fold up to the rear
Figure 97: Footrest, fold up to the rear, in standard
position
To
fold up the footrest to the rear
, move the
locking pin lever on the right and left side to the
vertical position to the footbar joints. Now you
can move the footrests to the rear.
Figure 98: Locking pin lever in a vertical position to
the footbar joint, opened
If the footrest should engage in the folded up
position, move the locking pin lever back to the
horizontal position to the footbar joint. The
locking pin levers are now not resting against
the footbar joints as the locking pins are not
engaged in the locking position yet.
Bracket with
cylinder pin
Recesses
M6 fixing
screws
with washer
Slots in the
support tube
Locking pin
lever in a
vertical
position
Fold-up to
the back
Footbar joint
