
STEP BY STEP
MULTI GAUGE CONTROLLER
STEP BY STEP
This chapter descries the con iguration procedure and irst start-up of the MG device.
. QUICK START
. Install the device on the vacuum system and make all the necessary connections - see chapter
. Switch on the device - see chapter . .
. Con igure the measuring channels - select appropriate gauges and set their parameters - see
sub-chapter . . .
. Set the threshold pressure values (setpoints) for both channels - see chapter . . . .
. In the event of working with gases other than nitrogen or air, enter the appropriate correction
factor - see chapter . . .
. If necessary, degas the ion gauges - see chapter . . .
. Choose the automatic or manual emission control type for each channel - see chapter . . .
. Check whether the threshold pressure values (setpoints) have been achieved and if the man-
ual emission control has been selected, press the
Emis
. button, to activate the ion gauge emis-
sion. Achieving the set setpoints is signalled by the green Setpoints diodes on the main win-
dow, and if emission is active the
Emis
. text appears - see chapter . . .
. COMMUNICATION INTERFACE CONFIGURATION
The following procedure let to con igure the RS
module to work with
bps baud rate:
. Press the Menu button.
. Click on the Setup menu.
. In the Setup menu select the Device Settings -> Communication -> Interface .
. From the
Interface
list select the
RS
.
. Click on
Baud Rate
.
. In the displayed list, select the appropriate transmission speed, e.g.
bps.
Page
User manual rev.