20
Table 8.2
Settings
(Default Value)
0 to 9999 Minutes
(Default : 0)
1 to 16
(Default : 1)
Parameter Description
SEGMENT NUMBER
Select profile segment number for editing the following
parameters.
TARGET SETPOINT
Set the Target (End) value for the selected profile segment
number.
Set the time duration of ramping or soaking for the selected profile
segment number.
TIME INTERVAL
Note : If the parameter ‘Common Holdback’ is set to ‘Yes’ on
Page-16, then this parameter appears only for segment
number 1 and is applied to all other segments.
Disable the Holdback Band (Set None) or set the scope (up, down
or both) for the profile holdback feature.
HOLDBACK TYPE
Note : If the parameter ‘Common Holdback’ is set to ‘Yes’ on
Page-16, then this parameter appears only for segment
number 1 and is applied to all other segments.
Set the band (deviation from profile setpoint) value for the profile
holdback feature.
HOLDBACK VALUE
(Default : -199)
Min. to Max. Range
specified for the
selected Input Type
(Default : None)
None
Both
Down
Up
User Manual
neuro 102 Plus
Profile Settings : PAGE-14
Note : The parameters on this page are available only if the profile feature is enabled on Page-16.
Use this list of parameters to set individual profile segment for the target setpoint, time interval, holdback type and value. Refer
Table 8.2 below.
For DC mA/mV/V
: 1 to 9999 counts
For Thermocouples/RTD
:
1 to 999 or 0.1 to 999.9
(Default : 1)
On-line Alterations : PAGE-1
Note : The parameters on this page are available only if the profile feature is enabled on Page-16.
The profile facilitates altering the running segment of the profile for the current execution without affecting the profile settings
on PAGE-14. That is, the changes made to the parameter values become applicable for the current execution of the segment
only. This allows adjusting the profile, if required, in accordance to some unexpected process changes. Refer Table 8.3.
