31
The following precautions should be strictly observed while installing the controller:
1.
The place of installation should be free of corrosive/combustible gases and electrically conductive pollution.
2.
Ensure that the place of installation is not subject to rapid ambient changes that can cause condensation. Also the Ambient
Temperature and Relative Humidity surrounding the controller should not exceed the maximum specified for the proper
operation of the controller.
3.
The place of installation should be adequately protected against excessive electrostatic or electromagnetic interference.
4.
The controller should not be subject to direct vibration or shock.
5.
The controller should not be exposed to dust, salt air, direct sunlight or radiant heat.
OUTER DIMENSIONS
The Figure 11.1 shows the outer dimensions of the controller.
MECHANICAL INSTALLATION
110mm
(4.33in)
10mm (0.39in)
Side View
Front View
Figure 11.1
Panel Cutout
45 X 45 mm
-0, +0.5 mm
(1.77 X 1.77 in)
(-0, +0.02 in)
10mm (0.39in)
38mm (1.5in)
Figure 11.2
PANEL CUTOUT AND RECOMMENDED MINIMUM SPACING
The Figure 11.2 shows the panel cutout requirements for a single controller and also the minimum spacing recommended if
several controllers are required to be mounted on a single panel.
User Manual
neuro 102 Plus
Section 11
PPI
OUT1
OUT2
MODE
48mm
(1.89in)
48mm
(1.89in)
1
2
Plus
neuro 102
AL
