Commander T Series PB# 4100032
Rev.C 03/12
PowerBoss, Inc. Copyright 2011
Page 79
Hopper Filter Cleaning
The dust control filter is a polyester type element filter. It
may be vacuumed, blown out with compressed air, tapped
against the floor or washed with soap and water.
1. If blown out with compressed air, use 100 psi or
less.
2. If washed with soap and water, use 40 psi water
pressure or less.
NOTE: Make sure the filter is thoroughly dried
while standing on its side before installing
in the hopper. Do not install or use a
wet filter. Drying time is approximately
72 hours if air dried.
Hopper Filter Replacement
1. Insert the panel filter.
2. Install the shaker motor assembly.
3. Install and tighten the four filter retaining screws and
isolators.
4. Hook the wire harness to the filter shaker motors.
5. Close the hopper cover and secure the latch.
PREVENTATIVE MAINTENANCE
