PowerBoss, Inc. Copyright 2011
Commander T Series PB# 4100032
Rev.C 03/12
Page 64
SWEEP COMPONENTS
Broom Door Flap Inspection
NOTE: Perform this inspection when the machine
is parked on a level surface.
1. Turn the machine off and lock the parking brake.
2. Inspect broom door flaps for wear and damage. Flap
clearance should be ⅛” (3.18 mm) above the floor.
3. Worn and damaged flaps should be replaced
immediately to maintain proper dust control.
Broom Door Flap Replacement and Adjustment
The flaps are attached to the broom doors by a retainer bar,
hex bolts and nuts. To remove the flaps, remove the nuts,
bolts and retainer bar. To adjust the flaps, loosen the nuts
and bolts, slide the flap up or down as needed. Retighten
the nuts and bolts.
PREVENTATIVE MAINTENANCE
