Pioneer XY-122 Скачать руководство пользователя страница 5

Страница: 5 / 92

1 Introduction

____________________________________________________________________________________________________________

1.2 Installation guidelines

WARNING

・

・
・

Full-range loudspeakers

・

Mid-high loudspeaker

・
・
・

・

WARNING

・

Use screws suitable for ceiling material and screw mounting parts in solid locations.

・

Make sure to attach a wire for preventing falling parts and equipment of adequate strength using holes for mounting
secondary safety wires.

Ensure that the floor, wall, ceiling, or stage surface can withstand the weight of the system. Consult a qualified
professional for advice if the strength of the surface is unknown.
After installation, you must confirm that the speakers are safely installed.

You must periodically check that the speakers are safely installed , without any loosen bolts, deterioration of parts, and
so on. Also you must check right after earthquake.
Wherever possible, avoid high stacks and use ratchet straps to secure loudspeakers together. Please also remember
that vibrations from subwoofer systems can shake other loudspeakers out of place, which may present a toppling
hazard. The use of ratchet straps and non-slip material is recommended to prevent this.
When this product is placed in an elevated place such as on a shelf or stage, a speaker may be moved by vibrations and
fall to the floor, causing an injury or accident. Take measures to prevent a speaker from sliding off a shelf or a stage,
etc.

At least two persons should together lift the speaker to install.
Give sufficient consideration to safety when performing the work.

The XY-81, XY-101, XY-122 and XY-152 come with pre-inserted mounting screws. These screws can be taken out and
used to attach either special mounting hardware designed for the product or commercially available mounting
hardware.
Make sure to attach a wire for preventing falling parts and equipment of adequate strength using screw holes not used
by mounting hardware.

The XY-2 yoke is equipped with hole for mounting on the ceiling or walls.
This mounting hole and included special bolt can be used to mount the XY-2 to the bottom of the XY-3B.

The sides of the XY-2 are equipped with the socket head bolts for adjusting the forward tilt of the speaker.

When attaching the speakers to the wall or ceiling, you should first confirm that the wall or ceiling being used is strong
enough to support their weight. If you are unsure then consult a specialist. If the speakers should fall then it could lead
to serious injury, and is potentially very dangerous.
Check to make sure that any mounting hardware used is enough to support the system, whether using special
hardware designed for the system or commercially available hardware. Make sure to read the Introduction section in
this manual and the instruction manual for the mounting hardware thoroughly before proceeding. Take every
precaution to prevent the product and associated parts from falling as they could cause serious injury if they fell onto a
person.

Make sure to use mounting hardware of sufficient strength to secure the speaker in place when using non-designated
hardware. The speaker could fall, causing accidents,if not properly secured.
The fall prevention wire must be attached to a suitably strong location. The strength of the location to which the wire
is attached being insufficient can lead to the speakers falling or cause accidents. The fall prevention wire and screw to
attach the fall prevention wire to the ceiling or wall are not supplied with the speakers, so please purchase them
separately.

http://pioneerproaudio.com/

Page 5 / 92