Pioneer XY-122, Руководство по установке

Страница: 44 / 92

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
(6)
Note:
・
(7)
Note:
・
The hole (Φ13) on the Hook-clamp(J) can be used to install the speaker
to the ceiling. (Fig.3-2-4-Q)
When the hook clamp is mounted in the very rear mounting point,
the inclined angle of the both enclosures is shown below.
36 deg(XY-122) and 29 deg(XY-152) when the angle between the
two enclosures is at 50 deg (minimum degrees) and
29 deg(XY-122) and 22 deg(XY-152) when the angle between them is
at 95 deg (maximum degrees).
Ensure the two commercially-available eyebolts are secured to the
mounting points on both edges of the top of the XY-122/152 enclosures
to suspend it with wire as a secondary safety feature. (Fig.3-2-4-R)
Eyebolts to be used as secondary safety feature cannot be mounted
if the angle between the 2 enclosures is below minimum degrees.
Since eyebolts should be mounted to the enclosure as secondary
safety feature, the angle between the 2 enclosures should be
between minimum degrees and maximum degrees in order to
mount the eyebolts.
Using the supplied M10 socket head bolt(K) and Nuts(O) , attach a hook-
clamp to the mounting point. Moving the pickup point to the rear of the
enclosure will add down-tilt, and moving to the front of the enclosure
will apply up-tilt. Ensure that two Flat washers(N) are used between the
Hook-clamp(J) and M10 socket head bolt(K) as well as the nut(O) and the
hook-clamp(J). (Fig.3-2-4-P)
Commercially
-available
eyebolt
Fig.3-2-4-R
(K)
(O)
(J)
(N)
(N)
Fig.3-2-4-Q
http://pioneerproaudio.com/
Page 44 / 92
©2018 Pioneer DJ CORPORATION