Pioneer XY-122, Руководство по установке

Страница: 43 / 92

3 Rigging And Caster Setting
__________________________________________________________________________________________________________
XY-152:
(2)
(3)
(4)
(5)
Note:
・
Remove the eight pre-inserted mounting screws on the top and the
bottom of the two XY-122/152 enclosures. (Fig.3-2-4-O)
Using the supplied M10 socket head bolts(B), tentatively align the
mounting holes on the Dual enclosure flying plate(A) with the mounting
points of both the top and the bottom of the enclosure. Tighten the bolts
over 15N·m torque. Ensure that the Dual enclosure flying plate, where
the Variable angle bracket is attached in the above (1), is attached to the
top of XY-122/152. (Fig.3-2-4-P)
Remove the two mounting screws pre-inserted M10 on both edges of
the top of the XY-122/152 enclosure.
Once the desired angles of the two XY-122/152 are set, fully tighten all
the M10 socket head bolts to lock the position in place.
The angle between the two enclosures can be adjusted shown in
Table.3-2-4-A
Ensure that four Flat Washers(D) are used between the Variable angle
bracket(I) and the bolts(L) as well as the nuts(E) and the Dual enclosure
flying plate(A). Tighten the bolts at 15N·m torque. (Fig.3-2-4-N)
Ensure that each four Flat Washers(D, G) are used between the Variable angle
bracket(I) and the bolts(L, F) as well as the nuts(E, H) and the Dual enclosure
flying plate(A). Tighten the bolts at 15N·m torque (only bolt(F): 7N·m torque).
Using the supplied M10 hex head bolts(L) and the Nuts(E) align the two
M10 holes in the center of the Dual enclosure flying plate(A) with the
mounting points of the Variable angle bracket(I).
WARNING: Please look carefully at the illustration below before
installing the Variable Angle Bracket to the plate and place the
Variable Angle Bracket in the right position to align its front and the
top front of the plate.
(B)
(C)
(D)
Fig.3-2-4-O
Fig.3-2-4-P
Front Back
3pcs
2pcs
Wide
Narrow
NOTE: A product label is stuck on the front of the
angle bracket.
http://pioneerproaudio.com/
Page 43 / 92
©2018 Pioneer DJ CORPORATION