Pioneer M-IS22, Руководство по эксплуатации

Страница: 42 / 46

42
En
Additional information 10
Troubleshooting
Problem
General
No sound
Can’t switch between functions
Timer doesn’t work
Remote control doesn’t work
Power doesn’t come on
CD player
CD won’t play
Tuner
Can’t tune into any radio stations
or sound is distorted
A stereo broadcast is played in
mono
Tape deck
Can’t record
Recordings are muddy or
distorted, or you can still hear a
previous recording under the new
one
Excessive tape hiss and over-
emphasized high frequencies
Dull, muffled sound
Recording made from the LINE 1
input are distorted
Recording made from the LINE 1
input very quiet
Remedy
• Check that speakers and other system components are properly connected.
• Check that the input selector is set correctly.
• If the cassette deck is currently recording, you can’t change the function.
• Make sure that the clock is set.
• Try replacing the batteries
• If a fluorescent lamp is near the remote sensor on the main unit, it can interfere with
remote operation.
• Make sure that you’re using the remote within its operating range.
• Check that system cables are connected properly.
• Check that the CD is loaded the right way (label side should be face out).
• Check that the CD is clean and free of scratches and other damage.
• Check that the function is set to CD.
• Check that the antenna is properly connected.
• Experiment with the placement of the antenna.
• Make sure that other electrical appliances (fluorescent light, hairdryer, etc.) are not being
used closeby.
• Check that the tuning frequency interval is set correctly for your region/country.
• If the mono indicator is lit, press MONO to switch it off.
• Check that the tape you want to record on still has the erase-protect tabs in place, or that
they are covered with tape, etc.
• Clean the tape heads.
• Make sure that Dolby NR is in the same position as when the tape was recorded.
• Make sure that Dolby NR is in the same position as when the tape was recorded.
• Set the LINE 1 input level to ATT ON .
• Set the LINE 1 input level to ATT OFF .